Pe extrusion machine (one mould for two media)

Technical parameter as follows:

Ⅰ.dryer hopper and auto loader 1 unit

   Dryer hopper Capacity: 50kgs

  Auto loader capacity :300kgs/h

II.65mm Extruder

Screw Diameter.：65mm     

Screw L/D：28：1  

Screw type：Special for HDPE

Gearbox:   (Gearbox is made of alloy cast steel)

Motor power：22KW   AC

Motor brand: siemens beide brand

Control type：Frequency inverter  ,Delta brand from TAIWAN

Heating zone：7zone

Temperature control: omron brand temperature controller from japan

Air blower cooling zone：6zone     （6sets of air blower, power：120W）

Electric control cabinet  

III. .Mould :1SET

  Material: S136H

   According to customer’s sample or drawing to make

IV.Vacuum calibration cooling table: 1set

Material： stainless steel

Three-dimension electric water tank shelf: 1Unit

Electric adjust: from back to front, up and down is adjusted manually

2.2KW Vacuum pump   

Water pump :2.2KW kw

Water box  1 set  

The length of table:2m and width 500mm

V.   Double haul-off machine: 1set

Motor power：0.75KW X2sets

Control type：Frequency inverter, Delta from Taiwan

Effective length: 400mm 

The width :60mm

VI.Double Cutting machine  1set

Motor power：0.75KWx2sets

 Inverter frequency       

Remarks：

1. Temperature controllers are HUB brand ;Chinese motor and inverter frequency is DANFOSS-HOLIP from Taiwan.

2. The screw and the barrels are all made of high quality nitride steel-38CrMoAlA, and are nitration austerely according to NATIONAL STANDARD, nitration hardness: screw≥740HV; barrels≥940HV. Nitration depth:barrels:0.6-0.7mm; screw:0.4-0.6mm, fragility is 2 grades。

3.The speed reducer box materials is made of alloy cast steel, contact surface of up, down box is grinded precisely . The gear wheel material is made of 40Cr, and normalizing , quenched tempering ,quenching heat treatment, the teeth deal with grinding and peeling eventually, the teeth surface harshness is Ra 0.8, and provided with damping, antifriction, low-noise and other characteristic。